|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: mounting of input selector posted by john8417 on April 11, 2007 at 06:48:43:
...and pre and post stress after the shaft has been turned. Many selector switches have spring bearing detents. Lubricating the bearing may cut down on torque stress. Personally I would mount it by the shaft and run lengths of flexible wire to the pc board just to be safe. Ray Hughes.
"I take you as you are
And make of you what I will,
Skunk-bear, carcajou, bloodthirsty
Non-survivor.
Lord, let me die but not die out." THE LAST WOLVERINE by James Dickey
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Depends on how much torque you apply to the shaft.... - grhughes 12:21:49 04/11/07 (1)
- Huh, huh, Hey Bevis, he said: "Depends on how much torque you apply to the shaft...." (nt) - Chris O 18:19:02 04/11/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
