|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: Ideally a cap and a resistor in parallel posted by Tre' on April 4, 2007 at 12:54:13:
Hi.A more common way is to go without any series resistor. Just parallel a 0.01uF to 0.1uF cap to each diode, depending on the current load. Higher load, go for larger cap values.
For ceramic disc, make sure choose HV (I would use min 3KV) to ensure linearity. LV ceramic is pretty non-linear.
c-J
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- The cap is in series of the resistor. - cheap-Jack 13:13:15 04/04/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
