|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: how do you plan to use them posted by RayP on April 2, 2007 at 09:19:22:
RayThey are reputed to be the lowest
distortion IDH drivers available.
I am going to drive PP 300Bs with them.
The rp is 1.6K and mu of 6.3.
Email me if you want the schematic.
ECC99/6W6GT in DRD with a CCS load
because they both like around 20mA.
So just a choke between them to bias the 6W6gt
and a cap from the 6W6GT cathode to ground.
ATV on the input and no resistors to be seen
except on the ECC99's cathode.
Hopefully I won't need any grid stops.DanL
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: how do you plan to use them - danlaudionut 09:33:36 04/02/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
