|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: Interstages with very high inductance posted by mqracing on April 1, 2007 at 09:53:57:
Can an IT or a CT autoformer be used on the grid of a cathode follower output stage? I am thinking that there will be over 400V rms AC, as the output stage will be running at 600VDC.I guess I am trying to figure out what are the challenges (if any) to build such a piece, as I may be crazy to even think about passing so much voltage through an IT or autoformer.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- what about a lot of swinging voltages? - nc 13:24:50 04/01/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
