|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: My 5U4GB filament gives scary flash when turning on the H+.. posted by stewcle on March 20, 2007 at 23:43:43:
Forget the switch. Why not just use a slower start-up 5V rectifier like a GZ34 or Bendix 6106 (although I don't necessarily want to drive up the cost of 6106's by recommending them to others)? I find that these ramp up slow enough to protect most output tubes. If there is a differential in the voltage drop, just adjust a resistor or choke as needed to hit the B+ you need.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: My 5U4GB filament gives scary flash when turning on the H+.. - Cpwill 16:49:12 03/21/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
