In Reply to: My 5U4GB filament gives scary flash when turning on the H+.. posted by stewcle on March 20, 2007 at 23:43:43:
I strongly suggest you REMOVE the B+ switch you installed.
your hypothesis is unfortunately wrong, and in-fact you are
causing problems instead of solving them by such an approach.
You could destroy your filter caps, rectifier, etc --and quite
possibly end-up electrocuting yourself. I'D REMOVE THAT SWITCH
ASAP. CAREFULLY! CAREFULLY! MAKE SURE FILTER CAPS ARE SHORTED
TO GROUND AND FULLY DISCHARGED BEFORE ATTEMPTING ANY WORK
ON THE UNIT.Good luck,
-T.M.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- BAD IDEA ALL AROUND! - Thomas Martens 09:19:17 03/21/07 (3)
- Re: BAD IDEA ALL AROUND! - stewcle 15:14:04 03/21/07 (2)
- Same difference..... - Thomas Martens 09:35:34 03/22/07 (0)
- Same difference - Russ57 16:28:42 03/21/07 (0)