|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: what are good sounding circuits for Electraprint choke-splitter? posted by freddyi on March 14, 2007 at 19:22:11:
I run PP 6B4G's, 5842 driver. Use Sansui 1000A output trans, on old Dynaco mk2 chasis. Stock dynaco power trans; choke input supply (choke bolted on the side fraken-amp style), fixed bias. 5842 has separate filament trans. I run 'em 15-18 watts (Sovtek).These ugly, rusty amps have simply SMOKED some amps praised here at club meets - on the right speakers (usually somebody trying to run slightly less-efficient speaks with low power SET's). While they do give up some SET 'magic', they're still DHT's. They have a firm hand on the bottom end, and complex works don't go 'mushy'.
I had a someone run a scope on the signal, no ringing as described below.
Scholl (posted below) helped me a LOT with the design. I'll probably rebuild these as 2A3 amps, as I only have one quad of Sovteks left.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: what are good sounding circuits for Electraprint choke-splitter? - bean 19:19:01 03/16/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
