|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: what are good sounding circuits for Electraprint choke-splitter? posted by Tre' on March 14, 2007 at 21:38:17:
I used an E180CC (paralleled) driving UL 7027A'a with an unbypassed
Rk. I ran it off a large 450VDC supply, used OPT's a friend found on the roadside (literally) they where off Eico HF-22's? The whole project was
kind of a joke, it went together fast, I figured it might sound barely ok.
Well, for a geek who normally goes to way more trouble in every area
of amp building and design, I was floored the second I heard it. How can this sound this good? There's no DHT's, UL (oh my), degenerative FB, 1.0uf coupling cap, etc...I only had it around for a few days before I loaned it to friend, who won't give it back now. Powerful, open, extremely detailed, even low level info, good.
This topology is probably even better with 2A3's, but I haven't tried that yet, as I'm focused more on SE experiments at the moment, but this is a great "no circuit" circuit...!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: what are good sounding circuits for Electraprint choke-splitter? - bobbyj 11:32:07 03/15/07 (1)
- Re: what are good sounding circuits for Electraprint choke-splitter? - Tre' 14:04:57 03/15/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
