|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: twisted pair wiring on a tube amp posted by jarthel on March 13, 2007 at 20:24:04:
What you are effectively doing is using the ground wire as a shield, however not a very good one, and you would be better in general to use a coax shielded cable instead. The advantage of a twisted pair is common-mode rejection, which requires a complete circuit.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: twisted pair wiring on a tube amp - David McGown 02:18:21 03/14/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
