|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: 120Vac on a 115Vac transformer posted by danlaudionut on March 10, 2007 at 10:44:32:
I used an isolation transformer (used off ebay) that had an adjustment switch 105, 115, 125 for the input voltage. That way I just set it to 125 and I get about 110 to 115 at the output(when loaded). The voltage does creep up a few volts under no load. I think it is either 250VA or 500VA. I was getting some ground noise due to my setup. But I may try it out again when I get finish recapping my Mark 3 amps since the B+ is over 500 volts when my AC in is 124V.I like the buck idea though!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 120Vac on a 115Vac transformer - LR-dan 21:29:53 03/10/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
