In Reply to: Re: Why Tre', you are so emotional !! Unbalanced Whiner, UGH! . posted by drlowmu on March 10, 2007 at 00:18:20:
With all due respect, Jeff, those Triad C-40X chokes have a DCR of 10 ohms. Wouldn't we be better using the Signal Transformer units that you mentioned earlier? The CH-1, while less than 1/3 the inductance (100mH vs. 320mH)it has only 1.5 ohm DCR.Both of these inductors were intended for low voltage supplies. Using them at the AC voltages we're talking about worries me a little. Not for safety reasons necessarily, I'm just worried that the chokes will easily saturate even when run well under their maximum DC current rating. They are subject to MUCH higher AC flux in this application. VERY generously over rating them in terms of DC current might prevent saturation. OTOH, maybe you like the sound of the supply with saturating chokes ... :)
Also, if anyone is interested in 'tuning' the supply to achieve the 'flywheel' effect (as described by Henry,) it seems to be easier with lower inductance, depending on the PT.
-- Dave
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- 10 ohms DCR!!!!!!!!!!!!!!!!!!!!!!!!! - Dave Cigna 09:30:58 03/10/07 (7)
- Ratings on Ls, voltages - drlowmu 06:51:25 03/13/07 (1)
- Re: Ratings on Ls, voltages - Dave Cigna 13:46:56 03/13/07 (0)
- Re: 10 ohms DCR!!!!!!!!!!!!!!!!!!!!!!!!! - drlowmu 15:03:29 03/10/07 (4)
- I'm begining to think that - mikeyb 13:46:06 03/11/07 (1)
- Re: I'm begining to think that - drlowmu 14:40:23 03/11/07 (0)
- Thanks, Jeff - Dave Cigna 15:33:08 03/10/07 (1)
- Re: Thanks, Jeff - drlowmu 18:34:35 03/10/07 (0)