|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
I've seen differing opinions on this (excluding tubes where the screen is limited to a low voltage anyway). Some believe that distortion is reduced with one the screen voltage equal or close to plate voltage, others believe the screen should be much lower than the plate voltage for best results. I find it confusing! Anyone have opinions on this?
This post is made possible by the generous support of people like you and our sponsors:
Topic - Power pentode/beam tetrode screen voltage - should it be near plate voltage or much lower? - Ray Moth 00:47:10 03/01/07 (3)
- Re: Power pentode/beam tetrode screen voltage - should it be near plate voltage or much lower? - Eli Duttman 16:32:02 03/01/07 (0)
- Re: Power pentode/beam tetrode screen voltage - should it be near plate voltage or much lower? - John Swenson 15:54:33 03/01/07 (0)
- Ideally, screen voltage should be significantly lower than plate voltage. - sser2 11:37:43 03/01/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
