|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Hi Eli D. aren't the Mills non-inductive ? posted by lovetube on February 21, 2007 at 16:30:53:
Yes and no. Mills employs the Ayrton-Perry winding technique to hold inductance WAY down, but some inductance, albeit SMALL, is always present. In any event, culling out matched Carbon comp. parts will cost you LESS.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Hi Eli D. aren't the Mills non-inductive ? - Eli Duttman 16:39:56 02/21/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
