|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Right on ! 5687 sounds good but not loud enough ... posted by Aria Seven on October 2, 2002 at 02:31:19:
I like the 6n1p in SRPP. It will give a little more gain than the 5687, but I don't think it will drive the 2a3 to full power without an active preamp ahead of it. Also it still may not swing enough voltage at your 146V or therebouts.If you wanted to get more complicated with a constant current loaded mu-follower type setup to maximize the gain from your driver that may work. I wouldn't intentially setup your amp to not deliver its full output or run the driver to clipping before full output. But thats just me.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Right on ! 5687 sounds good but not loud enough ... - zarniwoop 08:59:55 10/02/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
