In Reply to: HELP: High impedance load for SET amplifier posted by OperFan on August 6, 2020 at 01:17:03:
You will not harm the amp. The 16 ohm tap will be a fine match for the field coil. If you were able to do a frequency sweep to measure the impedance of the speaker it is highly likely that some frequencies would have less than 16 ohms impedance. Speakers are not resistors and the impedance is usually an average number.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: HELP: High impedance load for SET amplifier - Chip647 06:57:28 08/06/20 (5)
- RE: HELP: High impedance load for SET amplifier - OperFan 00:38:49 08/07/20 (4)
- RE: HELP: High impedance load for SET amplifier - Blackdog 04:39:52 08/10/20 (0)
- It will make less power but - Ralph 11:44:47 08/07/20 (2)
- RE: It will make less power but - PakProtector 16:15:12 08/08/20 (1)
- Not really - Paul Joppa 08:02:17 08/09/20 (0)