In Reply to: air tight /acoustic masterpiece 101 posted by kef on July 31, 2017 at 12:03:55:
This is an EL34 diagram, the only difference is that the Pin 1 is internally connected to Pin 8 in a KT88.
So what you do is take Pin 4 (G2) and unhook the ultralinear connection from the output transformer. Take that lead and put some heatshrink over the end so it does not contact anything.
Then take a 100 ohm 1 watt resistor and solder it between Pin 3 (plate) and Pin 4 (G2). Check the bias to make sure everything is cool/correct and you are good to go. Most cases the bias will not be adversely affected.
Then enjoy psudo-triode ( I like that connection better if you don't need the power)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: air tight /acoustic masterpiece 101 - Chip647 16:55:45 08/01/17 (7)
- RE: air tight /acoustic masterpiece 101 - kef 09:33:54 08/05/17 (0)
- RE: air tight /acoustic masterpiece 101 - kef 20:12:24 08/01/17 (5)
- RE: air tight /acoustic masterpiece 101 - Triode_Kingdom 07:33:59 08/02/17 (0)
- RE: air tight /acoustic masterpiece 101 - kef 20:30:04 08/01/17 (2)
- question - Tre' 08:07:43 08/02/17 (1)
- RE: question - kef 12:14:18 08/02/17 (0)
- RE: air tight /acoustic masterpiece 101 - kef 20:29:10 08/01/17 (0)