Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ SET Asylum ]
[ Alert Moderator ]

RE: What tubes to use with this Interstage Transformers?

Dave,

I am sure you can figure this out on your own. 4mA of current source from 5000ohm resistor driving an equivalent series circuit consisting of DCR, a low value C, and a high value L at 20Hz will result in a distorted waveform.

This will only work if the AC current at 20Hz is much higher like 100mA (smaller value resistor like 1K ohm)or the Signal Generator Voltage is much higher than 21V that mine can put out.

What is the max output voltage on your Signal Generator without distorted sine wave?


Regards,
James


.
.
.Thou shall not stand where I type for I carry a bottle of Certified Audiophile Air and a Pure Silver Whip.

This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]