In Reply to: RE: ELECTRAPRINT Single-Ended Output Transformers, DIY Modifications posted by kyle on July 27, 2016 at 04:36:11:
With all respect, how can you call this good for there very high prices?
They use M19 EI transformer laminations which is a non grain oriented steel (higher losses, high magnetizing force and lower exitation ). They didn't use the bobin optimally (extra high copper losses).Maybe the frequency response is good* (no info on there site) but at least two very important parameters are not good or even bad.
*but always less then when they used better cores.
Edits: 07/28/16 07/28/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: ELECTRAPRINT Single-Ended Output Transformers, DIY Modifications - Lenin 04:58:38 07/28/16 (0)