|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
|
|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
In Reply to: RE: Motor Run Caps for the BB Proof Amp posted by Paul Joppa on December 14, 2014 at 10:47:22:
"* The revised circuit has resistors across those caps to bleed them down when the amp is off - there should have been such a resistance in the first diagram as well."
I was wondering if that was the case.
"* I simulated the power supply in PSUD-2 to check the peak rectifier current and confirm that it is below the rated maximum with 50uF as the first cap. This is because we are drawing only 60mA; if we were drawing the full 175mA max rated current for the 5V4 then 50uF would be far too big a capacitor."
There only seems to be two choices; 45uf and 50uf. Choose you poison, or mine.
I get it. Stick to revision 2. Believe me. I will wait till it's finalized and tested before I order any parts. I wish Garg0yle the best of luck.
Jamie
Big speakers and little amps blew my mind!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Motor Run Caps for the BB Proof Amp - Mr_Steady 10:56:08 12/14/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
