In Reply to: BB Proof 2A3 DC posted by Garg0yle on December 5, 2014 at 20:22:08:
OK I think I am ready to apply a finish to the chassis(s).
I had more work to do then I thought.
A trip to theSource (Radio Shack was actually fruitful, as they had a couple of fuse holders I needed. I also picked up some binding posts, the first set were extremely cheesy, but they also had some spring load ones. I went with those.
Also I'm tired of filing out pretty holes for IEC sockets, so this time around I am going to use a M12 strain-relief pigtail. 7/16" round hole and it's done.
These decisions were made for expediency.
I still need some RCA jacks, but they are fairly common with a 1/2" hole, so I drilled for that size. (debated not even using a RCA socket, just a wire, but then I still need to grommet it and keep it secure so I wasn't really gaining anything in the effort department.)
Then I went to Home Depot to get a couple of suitable handles for the sides.
Eventually some small holes will need to be drilled for the choke and terminal strips, but the major machining is done. Hopefully I will be soldering some wire by the weekend.
Cheers.
△This message will self destruct in 10 seconds△
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: BB Proof 2A3 DC - Garg0yle 09:16:10 12/11/14 (0)