In Reply to: Help, the right channel of my 45 tube amp is out posted by audiowill on April 1, 2007 at 22:36:50:
Hello,The rectifier should be fine, otherwise there would be no sound from either channels.
It could be the tube pin conncetions, or coupling cap going bad.
Test if there is continuity between the leads leading to tube pins and the pins themselves. Check if the caps in that channel are shorted or not. Check the resistors values. Check if the OPT is shorted. If you do not know the original values, compare one side tho the other, and if there's a difference, you have found the culprit.Good luck!
Janos
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Help, the right channel of my 45 tube amp is out - Janos 00:27:47 04/02/07 (4)
- Swap the output tubes; then the input tubes... - Interstage Tranny 08:38:19 04/02/07 (3)
- Re: Swap the output tubes; then the input tubes... - Janos 16:37:25 04/04/07 (0)
- Re: Swap the output tubes; then the input tubes... - Ron Oehlert 10:41:12 04/03/07 (1)
- Re: Swap the output tubes; then the input tubes... - maxhifi 18:08:02 04/03/07 (0)