|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
|
|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
In Reply to: Yes, long live DIY posted by RioTubes on December 29, 2006 at 16:52:03:
I beleive that I made the voice coil too tight, and it rubs slightly on the magnet. When the elmer's glue dries, it makes the paper shrink. Quite a bit.
I hope with slightly larger diameter voice coil that won't be a problem, and I get the desired efficiency. I can increase efficiency by doubling the number of turns (and turning it into a 16 ohms driver instead of 8R). That makes a slight increase in total mass, and a quadrupling in inductance - a significant increase in sensitivity.I also use a 8in 95dB Fostex. (FE204). :) I like it so much, that I do not intend to replace it. I am making the DIY driver for a mono setup, that I want to make as DIY as possible. I don't know if I can turn out a DIY cartridge, but it will use DIY tonearm, TT, coupling caps, and some diy resistors and transformers, chokes.... I'm doing this out of curiosity. Will take a while to build.
Janos
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Yes, long live DIY - Janos 19:13:52 12/29/06 (2)
- You've probably seen the Altmann TT - RioTubes 20:13:20 12/29/06 (1)
- Re: You've probably seen the Altmann TT - Janos 10:51:13 12/30/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
