|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
|
|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
|
In Reply to: If you want good bass and transient response, then... posted by Thomas Martens on September 5, 2006 at 09:48:14:
Thomas,
... the first stage (that is also the dirver stage for the 2A3) works with 14 mA (so 8 mA should be too little) ... and my intention was to utilize a LCLC filter ... possibly with low DCR.I have read (in the tube DIY section) that low DCR power supply sounds better than standard filters.
So, I'd like to experiment low DCR chocke and low-uF Capacitor in the power supply ... but I cannot find any specific schematic with this implementation.Antonio
P.S.
Thomas ... why when i run the PSUD with the values reported in 300B section of this schematic (http://home.att.net/~chimeraone/axiom300bschematic.html) I obtain different Voltages (> 500 vs 385)?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: If you want good bass and transient response, then... - Antonio Tucci 05:17:19 09/06/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
