|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
|
|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
In Reply to: RE: Buffer - emitter resistor value? posted by 13th Duke of Wymbourne on December 24, 2024 at 00:35:36:
Thank you very much for your detailed response, mate. :-))
Re. your last sentence - "In summary, the 1kohm case allows you to drive a low load resistance with lower distortion but it will, counter intuitively, produce more distortion in a high load resistance case."
... as the Zin of the device following the phono stage is 10K - I take it that I will get lower distortion using a 4K7 ohm res than a 1K res?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Buffer - emitter resistor value? - andyr 03:18:50 12/24/24 (7)
- RE: Buffer - emitter resistor value? - 13th Duke of Wymbourne 13:59:45 12/24/24 (6)
- RE: BTW ... - andyr 19:01:15 01/01/25 (4)
- RE: BTW ... - 13th Duke of Wymbourne 11:12:47 01/03/25 (3)
- RE: Sure ... - andyr 16:36:08 01/03/25 (2)
- RE: Sure ... - 13th Duke of Wymbourne 12:06:05 01/04/25 (1)
- RE: Absoloootely no offence taken ... - andyr 15:36:41 01/04/25 (0)
- RE: Thanks again ... - andyr 16:56:19 12/24/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]