In Reply to: RE: Protection Cap vs. power-up sequence posted by Ozzie on October 11, 2012 at 20:17:01:
Do you actually "witness" driver overload or is (hopefully was..) it something that you'd find out at the next power up?
Had a Stasis 5, great amp but would make a good "pop" on power-up with the Maggies it was driving then. Never had a ribbon blown, though.
Hope it get's resolved with the new amps, did read up on Mr. Pass again after looking at your set-up. One of my favorite designers.
What do you mean by "The planer is exact"?
Back in the 80'ies we'd put fuses on drivers in the studio, some clients would always manage to make a bad decision on the board with the mains too loud already.
Good luck, active is the way to go.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Protection Cap vs. power-up sequence - Palmer 03:23:59 10/12/12 (1)
- RE: Protection Cap vs. power-up sequence - Ozzie 08:48:00 10/12/12 (0)