Home Propeller Head Plaza

Technical and scientific discussion of amps, cables and other topics.

[ Follow Ups ] Thread: [ Display  All  Email ] [ Propeller Head Plaza ]
[ Alert Moderator ]

Re: Prop head

>>> "As recently as two years ago this site was for Technical chat; an engineers hangout as it were. A place where the the folk who make the equipment could hash out ideas. You know, ideas engineer/artists could relate to." <<<

Precisely. So, why are not the people who make the equipment experimenting with putting all the components and bits and pieces which go into making the complete equipment through the freezing/slow defrost process before assembly ? See Ed Meitner's writings stretching back over 20 years !!! If Prop Head IS the place where the folk who make the equipment can hash out ideas, then why have I not seen Prop Head inundated with descriptions of these 'folks' experiences in that particular area ?

Is it or is it not an 'idea which engineers could relate to' ? If it IS, then why do we see nothing discussed on Prop Head about that technique. If it is not, then why not ?

Or, has it already been dismissed by these so called 'engineers' as merely a 'TWEAK' - i.e. As rp 1 has just said "But this is NOT the room for discussion of tweaks;"

Why don't you experiment for yourself ? Why don't you find out for yourself just what can be achieved ?
Regards,
May Belt.

This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]

Follow Ups Full Thread
Follow Ups
You can not post to an archived thread.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]