Home Computer Audio Asylum

Music servers and other computer based digital audio technologies.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Computer Audio Asylum ]
[ Alert Moderator ]

RE: Question re your pure linear PSU

Thanks for congratulations, cics!
1. Unfortunately there was no possibility to compare these two cMP2 directly yet. (About testing cMP2 later)
2. Connector P24: pins 1,2,12,13: +3.3 V; pins 4,6,8,9,21,22,23: +5 V; pin 10,11: +12 V; pin 14: -12V; pins 3,5,7,15,17,18,19,24: ground. I have placed two more photos in My gallery.
3. Switch on the mains switch on the zalman's rear panel (see IMG_0628_ in My gallery), push the power button on the zalman's front panel, that's all!
4. No, imho. Because the linear psu has low efficiency in comparison with the switched-mode psu and produce a lot of heat, hence it requires adequate cooling.
5. Yes.
Serge.
http://cmp2-mihaylov.narod.ru/

My cMP2: Windows XP SP2 Ru, GA-H55M-UD2H, i3-530, Corsair CM3X160C9DHX 1GB, system drive - Transcend IDE FLASH MODULE TS2GDOM40V-S FAT32, ESI Juli@, full linear PSU, NAS - WD My Book Live


Edits: 04/10/10
This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]