In Reply to: PiCorePlayer Beta 5 is Old News....Beta 6 is out posted by Dynobot on April 13, 2017 at 20:03:37:
"Yes, I have many things on my network (printer, LMS server) set to static IP addresses. I don't see anything in piCore where one can change the IP address. I looked in the router and there's a static IP address for it but I see nowhere to change the IP of RPI
I can see my network and password in the wifi tab of PCP on I can watch the
rpi boot and load the broadcom firmware and find the wifi adapter but it doesn't connect to the network."
Does the RPI show up in the WiFi section of the pCP page? If you press the Scan button?
You might try to set this up whilst the RPi is connected to the network with a CAT cable. Once I found the MAC address, I set that up with a static IP address in the router software.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: PiCorePlayer Beta 5 is Old News....Beta 6 is out - merlinus 14:32:53 04/14/17 (1)
- RE: PiCorePlayer Beta 5 is Old News....Beta 6 is out - Dynobot 14:37:15 04/14/17 (0)