Computer Audio Asylum Music servers and other computer based digital audio technologies.

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Computer Audio Asylum ]

---

[ Alert Moderator ]

---

Re: Winamp Asio volume question

Posted by Dawnrazor (A) on February 5, 2007 at 20:18:57

In Reply to: Re: Winamp Asio volume question posted by Presto on February 5, 2007 at 10:20:29:

P,

While this will accomplish the task at hand: make Dawnrazor stop tossing his bits, you really think that running a signal from balanced outs to single ended input through a reciever's pre-amp section to a single ended input on an amp that was run balanced before will yeild better results?

I find that very hard to swallow. See long long time ago, I used a HK ht amp as a pre to a Carver 2 channel amp. Then I wised up and ditched HT, and replaced the HK with a Carver pre. Then the Carver was replaced with a CJ, which was replaced by a cdp running direct (true, that had an analog volume contol I think)

Maybe HT receivers have improved, but I would be very surprised if i got better results.

I am not dismissing it out of hand and it is a good idea, but it does seem like a long shot.

WHich one would you suggest?

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---