In Reply to: Re: If you are into convolution posted by Presto on November 20, 2006 at 16:04:44:
Hey P,I think there is one possibility you missed. One can passively bi-amp using passive crossovers, but multiple amps.
If each amp has an in and an out, one could take a stereo amp and run into the "left" channel, and then out to the "right" channel. NOw BOTH outputs would have the same signal (say center), and you could use the stereo amp to drive the top an bottom of one speaker.
OH, and to complicate things, there are such things as line level PASSIVE crossovers too...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: If you are into convolution - Dawnrazor 16:39:47 11/20/06 (1)
- Just one? :o) - Presto 10:31:41 11/21/06 (0)