In Reply to: Installing New Output Tubes In M60's posted by RSG on July 15, 2006 at 08:10:18:
Atma-Sphere recommends burning in the new output tubes with just the heater circuit (stand-by) for 24-48 hours before applying full power to the tubes. Doing this is reported to improve the life of the tubes. Another recommendation is to back down on the bias initially when you do move to power the amp up, then gradually ramp everything up to the correct AC balance and bias. With a new set of tubes, check your AC balance and bias at least once a week until you find it is stable.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Installing New Output Tubes In M60's - Rushton 13:07:42 07/15/06 (2)
- Make that DC balance (offset) and bias /nt - Legendre 05:21:26 07/17/06 (1)
- Re: Make that DC balance (offset) and bias -- Oops, right: Thanks - Rushton 14:54:51 07/17/06 (0)