108.28.89.49
'); } else { document.writeln(''); } } else { document.writeln(''); } } else { document.writeln(''); } } // End --> |
This Post Has Been Edited by the Author
In Reply to: RE: All tube input and driver stage? posted by AJ on April 30, 2016 at 15:53:53
I bought my 2SWs completely on a lark, just "because". I wanted only to have the experience of hearing them and then thought I would pass them on to someone else of a similar level of craziness. But now I am addicted; I would never let them go. It took some experimentation, pain, and frustration to get them just right, but now I love them. Best of all, I can stay up all night listening to them, if work obligations permit, because my wife is oblivious to them; she cannot hear them at all in our bedroom, two floors above. Whereas, my big Sound Lab speakers are in the living room right below our bedroom; they must be turned off by 11:30, most nights, or I have a domestic dispute on my hands.Incidentally, the panels are very long-lived if not mistreated by a blowup of an amplifier, I think because they do not carry a quiescent charge. I bought a roll of aluminized mylar, which is what you need for rebuilding a panel, should the need arise. It's still available commercially, but I would advise stockpiling some, just in the rare case.
PS. Is that the (stereo) direct-drive amplifier, sitting down on the lower left in your equipment module? My only thought is not about stereo separation or any other niceties of monoblocks; it's more about the length of the speaker wires. They would need to be quite long and very well insulated.
Edits: 05/01/16Follow Ups: