74.96.191.12
'); } else { document.writeln(''); } } else { document.writeln(''); } } else { document.writeln(''); } } // End --> |
This Post Has Been Edited by the Author
In Reply to: RE: I was using a different chart posted by Ralph on June 05, 2012 at 13:49:13
Since I can see none of the numbers on the X or Y axes, and since the curves are not labeled, the graph means little to me, except to say that my measurements are nothing like that, assuming the bottom two curves are of impedance. There is no such huge peak at whatever frequency that is, with no resistor, using either their toroid or the AU transformer. My speakers were built in late spring of 2011. Anyway, if that peak is up to 40 ohms, then the impedance at lower and higher frequencies would appear to be too low to be ideal for our amplifiers. Looks like 5 to 10 ohms mostly. OK for an MA2 but nothing lesser.
Follow Ups: