In Reply to: Dun Mei... posted by mmcc73 on September 15, 2020 at 06:59:22:
Well the fact that the leads were disconnected made it a good bet that someone had already sorted out that the transformer had failed.
This is clearly a custom part. So you could have one designed and made up, which would likely run you about $500-$750.00. Or you could use a number of separate transformers to make up the voltages needed. The 6.3V filament winding is probably available as an off-the-shelf toroid. You might be able to find the other voltages except for the B+ for the output tubes- my guess is a custom transformer will be needed for that. Getting all this to fit under that power transformer cover might be a trick. But you might also have room for the smaller transformers (Bias and driver power supply) beneath the chassis.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- bad transformer - Ralph 08:17:32 09/15/20 (5)
- Dun Mei... - mmcc73 12:03:52 09/15/20 (4)
- transformer windings - Ralph 12:05:50 09/15/20 (3)
- Transformers... - mmcc73 12:16:28 09/15/20 (2)
- RE: Transformers... - Ralph 12:26:51 09/15/20 (1)
- Dun Mei... - mmcc73 14:11:39 09/15/20 (0)