In Reply to: I just need some pointers as to what is meaningful to measure posted by Penguin on April 6, 2015 at 07:37:16:
You will find a schematic that is quite similar to your amp at the link below. The driver voltages will be nearly the same:
Cathodes of V1 about 0.3V
Plates of V2: about 175V
Cathodes of V4: about -65V
Plate of V4: about 275V
B+ and B- are about 300V
To get an idea of your power tubes take a look at this link
If your power tubes are good it may be that some of the resistors in the output section have failed. In your amp the larger resistors on the power tube sockets are 1 ohm 5 watts. Some earlier versions have 3 watt resistors.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- schematic - Ralph 09:29:00 04/06/15 (3)
- Thank you - Penguin 20:08:01 04/06/15 (2)
- Follow up? - Lew 08:58:59 04/15/15 (1)
- on the stack of things.... - Penguin 09:05:00 04/15/15 (0)