In Reply to: RE: Help needed: OTL3 Front End Bias not reaching 85V posted by rhinohifi714 on January 30, 2015 at 19:48:53:
Thank you!
Tried swapping out the 6EJ7, but no luck. Tested all of the tubes on a tester and they test fine too. Think I found a resistor that has significantly drifted and ordered a replacement to try (right by the front-end bias test point, so that would fit with what I'm seeing). The caps appear to be fine and I'm a bit surprised given the amps age...guess driving ESL's are good for it. My OTL3 doesn't really match the schematics I have that well, so I need to try it to make certain that's the issue. I'll post what I find.
Thanks again!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Help needed: OTL3 Front End Bias not reaching 85V - unlisted 09:16:43 01/31/15 (2)
- RE: Help needed: OTL3 Front End Bias not reaching 85V - unlisted 09:37:00 02/06/15 (1)
- RE: Help needed: OTL3 Front End Bias not reaching 85V - Banat 17:57:56 02/06/15 (0)