In Reply to: RE: Distortion measurements Solid core vs Multi strand posted by Ralph on September 19, 2014 at 09:43:57:
"You might get into trouble with the differences being too hard to measure if you limit the scope (no pun intended...) of the exercise.
IOW, it is easier to see the differences (and hear) them when the change is a bit more global- such as building an entire preamp or amp with a certain brand of resistor, rather than just one resistor changed in one spot."
Personally, I will stick with the tried and proven scientific method. If you want to test the assertion that multi-stranded wire creates more distortion than single-core wire, then do a clean experiment that simply measures one against the other. Don't introduce extraneous factors like running the signals through a loudspeaker and thereby introduce confounding factors associated with acoustic measurements.
Chris
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Distortion measurements Solid core vs Multi strand - cpotl 18:00:57 09/20/14 (0)