Mikey, I'm reworking my 211 SETs to clean up a few loose ends. The existing grid chokes aren't gapped, so I've been looking at alternatives. Based on the schematic below, do you think an EXO-01 parafeed choke would work well at L4? This is a lower-Z circuit than most plate loads, so I think 100H is sufficient. Any comments will be appreciated.Edit: Just to be sure it's clear, the 6BL7 follower has both sections in parallel. I believe the output Z is less than 100 ohms. Total R in the cathode circuit (including the choke's DCR) is approximately 1,600 ohms.
Edits: 10/09/16 10/09/16
This post is made possible by the generous support of people like you and our sponsors:
Topic - Choke for Class A2 211 Grid? - Triode_Kingdom 13:28:49 10/09/16 (3)
- Another thought on this... - Triode_Kingdom 14:05:56 10/15/16 (2)
- RE: Another thought on this... - mqracing 15:43:40 10/16/16 (1)
- RE: Another thought on this... - Triode_Kingdom 13:12:48 10/17/16 (0)