MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ MagneQuest/Peerless Forum ]

---

[ Alert Moderator ]

---

RE: possible to re-wind EXO-45 to 46?

Posted by mqracing (M) on February 3, 2016 at 09:29:47

In Reply to: possible to re-wind EXO-45 to 46? posted by rockdoc on February 2, 2016 at 12:49:42:

It would be much,much more expensive to do a quote rewind as opposed to just building new transformers.

You would be paying to tear down the trans and then paying for a new winding.

Also your not going to get the lambs apart without hurting them. High perm materials are very sensitive and critical in terms of mechanical stresses. Bend or distort a lamination and it should go in the trash can. And remember that the lambs are "glued together" via varnishing or waxing.

It is not economic nor practical from a performance point of view to rewind transformers.

MSL











Builder of MagneQuest & Peerless transformers since 1989

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---