MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ MagneQuest/Peerless Forum ]

---

[ Alert Moderator ]

---

RE: MQ OPTs for Tubelab SE 300b

Posted by jdrouin (A) on July 27, 2015 at 09:30:26

In Reply to: RE: MQ OPTs for Tubelab SE 300b posted by Paul Joppa on July 26, 2015 at 15:04:55:

Thanks, Paul and braubeat. I hadn't considered parafeed before, in part because I've never read about any TSE builders using it. I did a search and came up with one person who in fact used the EXO-003 and a Robin Hood OPT, which he vastly preferred over the James OPTs he had used initially.

There wasn't much info about how he did it but I will write to find out. If parafeed requires a change to the circuit topology, this could be a real issue because the circuit is embedded in a PCB. It does have some variability through the use of jumpers.

Since this is my first build, I was planning to go with a more traditional SE OPT that nearly everyone uses for this project, but I'm definitely open to parafeed and am going to look into this more.

Question: if I were to go with the EXO-003 and either the EXO-050 or RH-60, what kind of wattage per channel do you think I'd get with 300Bs?

Jeff

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---