|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
|
|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
In Reply to: RE: BMS 4592 ND might be good to 300 Hz.... posted by Johno on July 25, 2023 at 17:38:05:
Remember the horn length is a major controller of how low the horn will load the driver. Figure it has to be 1/4 wl minimum and efficient operation begins about 1/2wl.
I have use this driver in products and also the B&C coax driver which is actually easier to make an ideal crossover between mid and high with than the BMS coax. Both can get down to 300Hz but takes a big exponential (curved wall) horn.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: BMS 4592 ND might be good to 300 Hz.... - tomservo 16:00:18 08/01/23 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
