Hi,
I've got two Altec 902-8T drivers but I'm a bit worried about the DC measurements.
One driver measures 7.6 Ohm and the other one 8.7
I measured it on the terminals in the clamps.
I'm a bit worried about the large difference and also I feel the values are quite high. Can someone advice on this perhaps. Many thanks!
This post is made possible by the generous support of people like you and our sponsors:
Topic - Altec 902-8T measuring question - Rico_111 10:05:08 01/10/21 (4)
- RE: Altec 902-8T measuring question - Bill Fitzmaurice 10:14:22 01/10/21 (3)
- RE: Altec 902-8T measuring question - Rico_111 11:33:23 01/10/21 (2)
- RE: Altec 902-8T measuring question - Bill Fitzmaurice 11:45:49 01/10/21 (1)
- RE: Altec 902-8T measuring question - Volker 10:08:16 02/05/21 (0)