Having tear my hair about having ARTA/LIMP to work with my computer, I decided to make the same setup, but using multimeters instead and making impediance curves in Excel.
By using a calibration resistor I got a deviation curve, which where subtracted from the real measurements. By doing so I think (hope) this is a fairly acurate measurement on my complete speaker setup (measured at the filter input).
So, What could be said about this curve?
Is it good, bad, worth the effort trying to be improved?
This post is made possible by the generous support of people like you and our sponsors:
Topic - What do you make of this? (Impedance curves) - pix 07:44:06 03/04/17 (18)
- RE: What do you make of this? (Impedance curves) - Mr_Steady 17:25:00 03/13/17 (8)
- Not quite here yet, bu at least I got ARTA/Limp up and running - pix 10:23:08 03/15/17 (7)
- RE: Not quite here yet, bu at least I got ARTA/Limp up and running - Mr_Steady 05:43:55 03/16/17 (6)
- RE: Not quite here yet, bu at least I got ARTA/Limp up and running - pix 06:45:36 03/16/17 (5)
- RE: Not quite here yet, bu at least I got ARTA/Limp up and running - Mr_Steady 09:09:33 03/16/17 (4)
- Purelly electrical - pix 14:10:45 03/16/17 (3)
- New measurements - pix 05:32:28 03/17/17 (2)
- Next measure - pix 05:43:38 03/17/17 (1)
- Third (and final) measurement - pix 05:53:29 03/17/17 (0)
- RE: What do you make of this? (Impedance curves) - freddyi 14:48:25 03/04/17 (2)
- RE: What do you make of this? - kitch29 05:43:32 03/07/17 (0)
- Woofer characteristics - pix 23:20:35 03/05/17 (0)
- RE: What do you make of this? (Impedance curves) - Bill Fitzmaurice 07:52:06 03/04/17 (2)
- Could it be a matter of limitations of the multi meters? - pix 12:08:52 03/04/17 (0)
- RE: What do you make of this? (Impedance curves) - pix 07:59:55 03/04/17 (0)
- This was the setup - pix 07:51:46 03/04/17 (2)
- Device under test - pix 07:58:22 03/04/17 (1)
- RE: Device under test - freddyi 15:29:38 03/04/17 (0)