In Reply to: RE: Hmmm.....got L-pads in mine.... posted by Steve O on January 9, 2017 at 18:39:58:
I switched to fixed resistors for two reasons:1: I did not like what they did to the sound.
2: To achieve the attenuation I needed, the L-pad needed to be set between 1 and 2 (on a scale of 0-10), making it difficult to match L and R settings.I determined the amount of attenuation needed by using a sound level meter, measuring the difference between wide open and what I liked. I also took AC voltage measurements at the driver, and converted that to dB's.(the results were amazingly close).
Edits: 01/10/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I WAS using L-Pads....... - Alpha Al 06:51:58 01/10/17 (0)