In Reply to: RE: Need help with RARE old Altec Lansing horn! posted by bwaslo on May 21, 2012 at 18:55:54:
I could probably solve the problem with a drill, but it would have to be drilling the driver to match the horn, not the other way around. The three hole mounting flange is only about 2 7/8 inch outside diameter. The two bolt driver mounting points are 3 inches on center (i.e. outside the perimeter of the 3 bolt flange). Nowhere to drill the holes on the flange. I could drill the driver to match the horn, but am averse to doing this. Not sure I could do it with the required precision anyway, even if I could figure a way to do it without damaging the driver.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Need help with RARE old Altec Lansing horn! - gilmorneau 20:02:45 05/21/12 (0)