Need some advice on terminals to use for my latest crossover build.I want to run all the connecting wires underneath the board, leaving the components on top of the board. I thought of using binding posts for all the connecting points, but it becomes very expensive, as I will have 10 connection points.
Then I thought to use brass threaded rod.........I can just put a nut & washer on the bottom & on the top I could put a washer with a brass domed nut to give a better finished look.
What is the opinion of the conductivity of brass for these connections? I know copper would be better, but I have found that impossible to source.
I would normally use a terminal block from Mouser (538-38780-0110) which is zinc chromate plated screw terminals in a thermoplastic housing.
Any thoughts appreciated,
John
Edits: 02/04/12
This post is made possible by the generous support of people like you and our sponsors:
Topic - DIY Crossover Help - sootshe 00:00:41 02/04/12 (6)
- RE: DIY Crossover Help - Pro Sound Guy 07:22:53 02/06/12 (0)
- RE: DIY Crossover Help - Skip Pack 09:59:33 02/05/12 (1)
- RE: DIY Crossover Help - sootshe 13:49:22 02/05/12 (0)
- RE: DIY Crossover Help - Don Bunce 10:49:47 02/04/12 (2)
- RE: DIY Crossover Help - Jim D. 16:13:29 02/06/12 (0)
- RE: DIY Crossover Help - sootshe 17:57:53 02/04/12 (0)