High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ High Efficiency Speaker Asylum ]

---

[ Alert Moderator ]

---

Re: What's the usual DCR on TAD TD-4001 drivers?

Posted by Paul Butterfield (P) on April 14, 2007 at 12:25:20

In Reply to: What's the usual DCR on TAD TD-4001 drivers? posted by basement_junk on April 12, 2007 at 14:31:03:

Hi Donnie,

The DCR for my (8-ohm impedance) TD-4001 is 7.2 ohms.

If you had any 16 ohm VCs, they would measure somewhere between 11 to 14 ohms DCR. Your used 16 ohm units have had their VC/dome assemblies replaced with 'newer' 8 ohm units.

FYI, the Radian (8-ohm impedance) replacements are a nominal 4.6 ohms DCR, with mine measuring at 4.4 ohms DCR.

HTH, Paul B

"Those who hear not the music think the dancers mad."
- Angela Monet

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---