Just finished last night after a 12hr workout on these.. I have about 10hrs of music on them & results are better than my previouse OB setup. 1st order .022uf Vitamin Q PLLXO on the 300B PP, BASH 300S plates running @ 150 for the Vifa m26wr-09-08's, then off & on a .22mH foil air coil on the B200 for 4250Hz, then a single 2uf film cap for 10K on the G2 ribbons, no padding. I sometimes run the B200's clean with only the .022uf PLLXO at input of the 300B PP amp set at 150hz cut. The lower 18" of baffle is doubled up 3/4 for 1 1/2" thickness w/ PL200 as the glue, also screwed., all stainless hardware & drivers are held extremely well. Test clips for my speaker wire....lol........Baffle size is 18"W at the top portion, 24"W at bottom area, 40" tall..
This post is made possible by the generous support of people like you and our sponsors:
Topic - My new B200 OB version... - JANDG 13:19:45 02/23/07 (0)