|
Headphone Heights Welcome to Headphone Heights, the place for all your ear bud discussion |
|
|
|
Headphone Heights Welcome to Headphone Heights, the place for all your ear bud discussion |
|
In Reply to: Wirering headphones? posted by Tweaker456 on September 4, 2014 at 14:17:24:
It depends a bit. If your headphone cable splits before going to the ear cups, you sure will be happy that you have 4 wires to use.
If you have a headphone where the wire only enters on one side (one earcup), then you can probably omit one wire.
If you would like to wire for a balanced connection, you will want to use all four of the wires regardless.
I would also connect the shield at the plug end.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Wirering headphones? - Caucasian Blackplate 07:47:00 09/05/14 (7)
- RE: Wirering headphones? #2 - Tweaker456 12:25:07 09/05/14 (4)
- RE: Wirering headphones? #2 - Caucasian Blackplate 20:02:13 09/06/14 (3)
- Also the quality of the wire depends upon. . - John PA 07:44:27 09/08/14 (2)
- RE: Also the quality of the wire depends upon. . - Caucasian Blackplate 09:27:34 09/10/14 (1)
- Yes, I would agree. . . - John PA 17:55:46 09/22/14 (0)
- Mine enter on one side - Tweaker456 12:22:41 09/05/14 (1)
- One ground for each ear cup. . - John PA 07:46:13 09/08/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
