Home VK Music - Elekit & Triode Japan Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

RE: Elekit TU-8200- won't play music




Thanks for your help, Victor. I took the amp apart and reheated all the solder connections between units 4 & 5, paying special attention to all the CN connectors. I didn't see any glaring solder issues — maybe one light solder on the solders between the boards and just maybe a solder bridge between two of the close pins on the 40 pin connector which I desoldered and re-soldered. I made sure to really tighten down the M5 flange nuts on the speaker posts since it seems like that's a physical connection. I sent a picture of unit 4 with my solders.

When I turned it on again, I still have the LED and tubes lit, but no music. It sounded like for a moment I had an intermittent signal, kind of static-y, but then nothing. No music. I hear more transient pops now when I change the input, but that's about it.

Any other ideas are welcomed. Thanks. Mike 415-3057703





This post is made possible by the generous support of people like you and our sponsors:
  Take Five Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.